- A useful alert compares what the machine measures with a limit: the manufacturer’s or one you configure.
- It says what happened, when and on which machine, and it’s recorded even if nobody reads it at the time.
- The record is useful later too: use of hired machines, warranties and maintenance warnings.
What a good alert is
It isn’t a light coming on in the cab. It’s a message saying what happened, on which machine and when, reaching whoever needs to know, and stored. For example:
- “Yesterday at 10:32, oil pressure fell below the manufacturer’s recommended minimum.”
- “Three days above the recommended temperature. If this continues, it may deteriorate.”
- “Few hours left until its service. Customer notified today at 9:00.”
Three kinds of limit
| Limit | What it is | What it’s for |
|---|---|---|
| Manufacturer’s | The recommended values for each machine. | Knowing when it’s working outside what it should. |
| Yours | The ones you configure, stricter if you wish. | Finding out before reaching the real limit. |
| Trend | Comparing with how that machine normally behaves. | Seeing what’s slowly getting worse, even before it passes. |
What to watch
- Pressures: oil, hydraulic, air and fuel.
- Temperatures: engine, coolant, oil and hydraulic.
- Electrical: voltages and battery. Voltage surges and drops damage electronics, and without a record they can’t be proved.
- Starting: repeated failed attempts.
- Use: service hours approaching or missed, idling and leaving an area.
- Fault codes: which appear and when.
Exact values depend on each machine and its manual. That’s why they’re configured machine by machine.
How to keep people paying attention
The biggest risk with an alert system is warning so much that it gets ignored. Four rules:
- Levels: information, attention and urgent. Only urgent interrupts.
- Time: a one-second spike isn’t half an hour above the limit.
- Recipient: pressure to the workshop; use of a hired machine to whoever manages the hire.
- Review: what goes off a lot and doesn’t help gets adjusted.
What’s recorded is valuable later
An alert helps in the moment. Its record helps months later:
- Hired machines: you check how they were used, with dates.
- Warranties and claims: you have your own history of what happened, which doesn’t vanish even if a fault code is deleted on the machine.
- Maintenance warnings: there’s a record that you warned and when.
- Repeated breakdowns: you see what was happening before each one.
If you’re worried about touching the machine
The equipment works by listening to the signals: it reads, it doesn’t write. It changes nothing about how the machine works. And telematics doesn’t operate it remotely: it gives you information to decide.
To see what’s measured and how the data travels, read machinery telematics: what to measure and why. Applied to your fleet, in remote heavy machinery monitoring.